Projector Installation
- Secure the projector base at the desired installation point and drill screws through the base holes until it is firmly attached.
- Rotate the base to adjust the projection direction.
- Twist the lens slowly until the image is clear, then tighten the ring on the lens to secure the waterproof rubber ring for protection.
Important: Avoid Installing Under the Following Conditions
- Poorly Ventilated Areas:
- Ensure good ventilation. Avoid placing the machine where the vent could be blocked or covering the machine body, as internal heat buildup could affect the lamp’s lifespan.
- Dusty and Smoky Environments:
- Do not install the machine in areas with excessive dust and smoke, as dust on the lens can degrade the projection quality.
- Exposure to Rain:
- Indoor lamps should not be exposed to rain. Ensure proper waterproof measures if installing under eaves or canopies.
- Only professionals should disassemble the projector. If you need to replace the gobo, make sure to switch off the power and let the device cool for 5 to 10 minutes to avoid burns.
Gobo Installation
- If replacing the gobo yourself, undo the screws on the front cover.
- Remove the semicircle spring snap ring.
- Insert the gobo with the front facing inside (the back facing yourself).
- Place the snap ring into the disc and use it to clamp the gobo tightly. Be cautious with the pressure to avoid damaging the lens.